The second, and more precise, method of dragging a sync point is using the scrubbing drag. The first is useful when you want to snap a sync point to a grid location, in this case you can enable Grid Mode and use the Time Grabber Tool to drag the sync point to a new location. ![]() If you wish to move sync points manually, you can do so again in one of two ways. Go to View > Clip > Sync Point as seen below.īit of a strange one, but something that can waste some valuable time if you’re sat scratching wondering where they have gone! Dragging Sync Points Whether they are hidden and you wish to show them, or they are visible and you wish to hide them, the menu option is the same. One little ‘gotcha’ you may run into within your sessions is finding that the sync points of your audio clips are hidden. The second way to delete them is to chose the Time Grabber Tool, then while holding Option (Mac) or Alt (Windows) click the sync point. The first, and easiest, way we can delete a point is to highlight the clip containing one and then got to Clip > Remove Sync Point as shown below. There may be occasions where you no longer need a sync point and want to remove them, thankfully this is as simple as it is creating them and can be done in one of two ways. So you have your first sync point working! Give it a go, you should find that in Grid Mode your clip Sync Points now snap to the grid as opposed to the clip start/end. It should be noted that if you perform this again at a new location within a clip already holding a sync point, the sync point will move to the new position, a single clip can only hold a single sync point. You should now notice a small arrow at the bottom of the clip with a vertical grey line defining the sync point location. Next, from the Clip menu select Identify Sync Point as shown below. Note: I like to use the Tab To Transient tool when wishing to highlight the very beginning of a transient. Using the Selector tool, click on the point within a clip that you would like to sync to. ![]() Defining Sync Pointsįirstly you will want to enable Slip Mode, if you are not sure how then you may want to read our article on Edit Modes before continuing on. ![]() Note: Sync points can also be used to align a clip point to a particular SMPTE or Bar/Beat location as well. These points allow you to align a specific point of the clip to the grid of your sessions within Grid and Spot mode. Sync points can be added to any MIDI, audio, and video clips, not forgetting clip groups either. You will no doubt have experienced locking the start or end of a clip to a grid within Pro Tools, but what about when we want to snap a transient within the clip to a grid without cutting it short? In walks Sync Points. Synchronicity within a Pro Tools session is usually something pretty important, whether it be the placement of a foley effect within a film soundtrack, or a kick sample in time with the original.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |